TORK CRAFT 1200W Polisher With Wool Bonnet 180mm | POL02

Description

Tools for every job.

The TORK CRAFT Polisher With Wool Bonnet 180mm POL02 is a power tool used in the finishing process, used with polishing buffs and compound sponges to yield a dramatic difference on a painted surface.

FEATURES

• Professionally manufactured for the automotive paint care and detailing industries.
• Ergonomically designed to reduce fatigue in long term use.
• The polisher has various hand-held positions to better hold the polisher at angles.
• Gear system has a two-level deduction. With two times the amount of torque than a single gear set polisher.

APPLICATIONS

• The objective of polishing is to remove imperfections in the clear coat that cause the paint to look dull.
• Surface imperfections can include swirls, scratches, water spots, etchings, industrial fallout, oxidation, etc.

HOW TO POLISH A PANEL

1. Preparing the panel:

• Sometimes a panel has fine overspray left from spraying the clear coat. This needs to be removed by lightly sanding with a fine abrasive paper. All over-spray need to be sanded out up to P1500 grit.
• The panel should be washed when all spray-finishing defects have been removed. Any dirt particles could cause scratch marks when polishing.
• Tight curves and ends of the panel should be masked off to prevent the effects caused by point pressure. The polisher should always be used on flat surfaces.

2. Applying the polishing compound:

• A five rand coin amount of polishing compound should be applied to the buff. Switch the polisher to it&s lowest speed setting.
• Switch on the polisher and gradually spread the polishing compound over the panel.
• Keep moving the polisher on the panel to have as little amount of pressure and friction.
• The polishing compound will remove the scratch marks caused by the P1500 sandpaper, and it will bring out an impressive gloss finish.
• Remove the masking from the panels and apply the polishing compound to a microfiber cloth. Hand polish (by moving your hand in a small circular motion) the tight curves and ends in the panels until the same finish is achieved as from the polisher.

3. Wash the panel when finished:

• Wash the panel after polishing to remove any residue from the polishing compound.